Sparrow on signet
What you'll learn
- How to run Sparrow on signet instead of the real network
- How to tell which network Sparrow is on
- What the "proof of work target" error means
Sparrow Wallet is the computer half of the build: the watch-only wallet that builds transactions and broadcasts them. It must run on signet, the test network, never on mainnet.
Start Sparrow in signet mode
Section titled “Start Sparrow in signet mode”Sparrow keeps separate settings for each network, and which network it uses depends only on how it’s started. Started normally, it uses mainnet.
Start it with the -n signet option. On Windows, if Sparrow is installed in its default location, you can run this in PowerShell:
& "$env:LOCALAPPDATA\Sparrow\Sparrow.exe" -n signetA desktop or Start-menu shortcut whose target ends in -n signet does the same, and is handy for every later session.
Connect to a signet server
Section titled “Connect to a signet server”Sparrow needs a server to see the signet network. Open Sparrow’s preferences, go to the Server settings, and connect to a signet server. Sparrow can use a public server, or you can enter another signet Electrum server as a private server.
The “proof of work target” error
Section titled “The “proof of work target” error”If you see announced block header at height … does not meet its claimed proof of work target, Sparrow is running in mainnet (or testnet) mode but connected to a signet server. Signet blocks are valid under signet’s rules, not mainnet’s. Quit every Sparrow window and start it again with -n signet. Don’t point Sparrow’s mainnet settings at a signet server.
Sparrow rewrites its settings files when it exits, so close it before editing them by hand.
Set the QR density to its lowest
Section titled “Set the QR density to its lowest”When Sparrow shows a transaction as an animated QR, it can make the frames denser or lighter. The ESP32-CAM reads small, light frames much better:
- At Sparrow’s lowest density, the camera read about one frame per second, and a one-input transaction was complete in about 12 seconds.
- At the default density, it read about one frame every ten seconds.
So whenever Sparrow shows a QR code for the device, choose the lowest density.
Before you continue
Section titled “Before you continue”- Sparrow’s title bar says Signet.
- Sparrow is connected to a signet server.
You’ll create the watch-only wallet in the next step, once the device has a seed loaded.